This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Folks,
If I set my TD-W9970 up as a modem only device and later want to get back as a router do I have to reset the device or can it still be accessed via a web interface?
Appreciate the default is 192.168.1.1 as a router but unsure as to how management is achieved when set as a modem
Geoff
If you use it as a DSL router with PPPoE session configured then it should be enough to re-configure as wireless router via WebGUI (192.168.1.1)
If you use it as a DSL router in Bridge mode then it might not be accessible on it's WeGUI so just reset and re-configure.
As a general rule if you can't reach it via WebGUI (192.168.1.1) from inside your LAN, then reset and re-configure at your desire.
@terziyski It does still show up under the default ip address.
As mentioned in another thread but I shall repeat here in case someone reads it; my TP-Link router is connected to a powerline (homeplug) adapter so the laptop I amusing for configuration need not be in the same room as the router, makes it very easy.
Geoff
Helpful: 0
Views: 864
Replies: 2
No one has voted for it yet.
We use cookies and browser activity to improve your experience, personalize content and ads, and analyze how our sites are used. For more details, please read our Privacy Policy.
