One Mesh is Supported in Access Point Mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

One Mesh is Supported in Access Point Mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

mvsiva

2021-05-05 17:00:15 - last edited 2021-05-06 02:59:21

Posts: 9

Helpful: 1

Solutions: 1

Stories: 0

Registered: 2021-05-05

One Mesh is Supported in Access Point Mode

2021-05-05 17:00:15 - last edited 2021-05-06 02:59:21

Model: Archer AX20

Hardware Version: V1

Firmware Version: 1.2.0 Build 20201023 rel.69987(5553)

Model : TP Link Archer AX20 v1.20 AX1800 Wi-Fi 6 Router

I upgraded the firmware to 1.2.0 Build 20201023 rel.69987(5553) which claimed support for OneMesh. But since the Router was in 'Access Point Mode', OneMesh was not getting enabled.

After I changed the mode to 'Wireless Router Mode', only then the OneMesh was getting enabled? Is it that in access point mode, OneMesh is not supported?

1 Accepted Solution

terziyski

LV7

2021-05-06 00:11:03 - last edited 2021-05-06 02:59:21

Posts: 7137

Helpful: 5351

Solutions: 1219

Stories: 7

Registered: 2013-10-12

Re:One Mesh is Supported in Access Point Mode-Solution

2021-05-06 00:11:03 - last edited 2021-05-06 02:59:21

@mvsiva

Yes, it is. Check this FAQ - Q8/A8.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".

Information

Helpful: 0

Replies: 2

One Mesh is Supported in Access Point Mode

One Mesh is Supported in Access Point Mode

Information

Voters 0

Tags