Change of ISP can’t get my extender to recognise the new one
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Change of ISP can’t get my extender to recognise the new one
I recently changed my ISP and have a new router. I have tried a hard reset on the wireless adapter and have also connected it directly to the new router via Ethernet. Yet when I try to connect it still shows the name of my old router and will not accept the password of the new one.
how can I get it to recognise my new router
Re:Change of ISP can’t get my extender to recognise the new one
Reset the extender to factory defaults:
Then go to Chapter 2 of your user guide to reconfigure the extender from scratch, connecting it to the new router.
Ethernet port is used when you configure the device in AP mode or as a wireless adapter.
If this was helpful click once on the arrow pointing upward.
If this solves your issue, click once the star to mark it as a "Recommended Solution".