TL-WN725N v3 - firmware load failed

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-WN725N v3 - firmware load failed

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-WN725N v3 - firmware load failed
TL-WN725N v3 - firmware load failed
2021-07-19 14:14:26
Model: TL-WN725N  
Hardware Version: V3
Firmware Version:

Hello,

 

I am trying setup a TP-Link TL-WN725N USB WiFi dongle to work under an ARMv7l using the official beta Linux drivers. I've cross-compiled the driver module for an iMX6/QD board. The driver loads successfull, the confiuration setup is read from the eFUSE but the firmware fails to load. I am getting the following error:

[ 1513.849204] RTW: _netdev_open(wlan0) , bup=0
[ 1513.855913] RTW: Set RF Chip ID to RF_6052 and RF type to 3.
[ 1513.867608] RTW: reg 0x214, usb write 1 fail, status:-71 value=0x6ef8d400, vendorreq_times:1
[ 1513.881968] RTW: reg 0x214, usb write 1 fail, status:-71 value=0x6ef8d400, vendorreq_times:2
[ 1513.896732] RTW: reg 0x214, usb write 1 fail, status:-71 value=0x6ef8d400, vendorreq_times:3
[ 1513.911096] RTW: reg 0x214, usb write 1 fail, status:-71 value=0x6ef8d400, vendorreq_times:4
[ 1513.925976] RTW: reg 0x214, usb write 1 fail, status:-71 value=0x6ef8d400, vendorreq_times:5
[ 1513.936306] RTW: [dvobj:ac2df000][ERROR] continual_io_error:5 > 4
[ 1513.944767] RTW: rtl8188e_FirmwareDownload fw:NIC, size: 15262
[ 1513.952474] RTW: rtl8188e_FirmwareDownload: fw_ver=1c fw_subver=0000 sig=0x88e1, Month=14, Date=27, Hour=7e, Minute=3b
[ 1513.965544] RTW: =====> _8051Reset88E(): 8051 reset success .
[ 1513.973148] RTW: _FWFreeToGo: Polling FW ready Fail! (1, 0ms), REG_MCUFWDL:0x00000000
[ 1513.983295] RTW: FWDL fail. write_fw:0, 10ms
[ 1513.989715] RTW: rtl8188eu_hal_init: Download Firmware failed!!
[ 1513.997677] RTW: rtw_hal_init: hal_init fail
[ 1514.003958] RTW: -871x_drv - drv_open fail, bup=0

when I try to activate the interface with `ifconfig wlan0 up`. The dongle is plug-in into an USB-2.0 port. I can query the dongle with `iw list` but I cannot use it

because of the above error.

Any help is appreciated. Thanks.

  0      
  0      
#1
Options

Information

Helpful: 0

Views: 492

Replies: 0

Related Articles