Region : Portugal

Model : TL-WA730RE

Hardware Version : V2

Firmware Version :

ISP :

Greetings

I am currently working on a project for my university. That main objective is to get SNMP values from an access point, and monitor them. The SNMP objects I need to retrieve are in the IEEE 802dot11-MIB, dot11FailedCount, dot11FCSErrorCount and dot11RTSThreshold.

So I connected my TP-Link WA730RE Range Extender / Access Point (in AP mode) to my laptop and successfully ran the command snmpwalk, to get all the objects available, but there were none from the 802dot11-MIB. However, when I go to the configuration page on the device, under "Wireless" -> "Wireless Advanced" I can configure the "RTS Threshold" value. Is this made through SNMP or via linux internal command on the device?

I would also need some MIB object to know the system load. (CPU load or something).

Could you recommend me any other TP-Link product that supports the 802dot11-MIB and has the system load available via SNMP?
Does the WA730RE have these capabilities, and I am doing something wrong?

Thank you for your attention