Guest network isolation in AP mode after firmware upgrade

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Guest network isolation in AP mode after firmware upgrade

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

drazgo

2021-11-30 14:05:55 - last edited 2021-11-30 15:54:51

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2021-11-30

Guest network isolation in AP mode after firmware upgrade

2021-11-30 14:05:55 - last edited 2021-11-30 15:54:51

Model: Deco M9 Plus

Hardware Version: V2

Firmware Version: 1.5.53 build 20210309 rel 36309

Hi everyone,

I just upgraded the firmware on my tplink deco m9 plus to have the guest network isolation feature in AP-mode.

After the upgrade, i can see the option in the wifi-menu on the deco-app, but when i activate it, my guest network still isn't isolated and i am still able to acces all LAN-devices through that network. Is that a common problem, does this need to be fixed in a future firmware-update or am i doing something wrong?

Thanks in advance.

Kind regards.

1 Accepted Solution

Alexandre.

LV6

2021-11-30 15:01:32 - last edited 2021-11-30 15:54:51

Posts: 4071

Helpful: 2380

Solutions: 556

Stories: 0

Registered: 2020-10-22

Re:Guest network isolation in AP mode after firmware upgrade-Solution

2021-11-30 15:01:32 - last edited 2021-11-30 15:54:51

@drazgo

Activate guest network isolation, wait for about 5-10 minutes, then check if you have access to LAN from Guest (you shouldn't). When I tested that on my Deco mesh with M9s, I have found Deco needs a bit of time to propagate that configuration change to all its nodes. Initially, I also thought the isolation feature is not working.

Information

Helpful: 0

Replies: 2

Guest network isolation in AP mode after firmware upgrade

Guest network isolation in AP mode after firmware upgrade

Information

Voters 0

Tags