Change IP Address

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Change IP Address

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Change IP Address
Change IP Address
2022-01-18 19:35:55 - last edited 2022-01-19 09:51:23
Model: Deco M5  
Hardware Version: V3
Firmware Version: 1.5.7 Build 20210819 Rel 43499

In the advanced Settings, when I change my LAN Ip from 192.168.68.1 to any open address on 192.168.0.xxx I get an error that LAN IP address and WAN IP address (192.168.0.34) cannot be on the same subnet. In this specific case I'm using 192.168.0.100 - not 34 as the error indicates. What am I doing wrong?

  0      
  0      
#1
Options
1 Accepted Solution
Re:Change IP Address-Solution
2022-01-18 21:20:34 - last edited 2022-01-19 09:51:23

[SOLVED] I didn't realize the Operation Mode needs to be in Access Point [ap] mode.  Changed the setting in advanced settings and all works fine now.

Recommended Solution
  4  
  4  
#3
Options
2 Reply
Re:Change IP Address
2022-01-18 19:40:51

I understand that the Deco hub is using 192.168.0.34 on my ethernet nextwork.

  0  
  0  
#2
Options
Re:Change IP Address-Solution
2022-01-18 21:20:34 - last edited 2022-01-19 09:51:23

[SOLVED] I didn't realize the Operation Mode needs to be in Access Point [ap] mode.  Changed the setting in advanced settings and all works fine now.

Recommended Solution
  4  
  4  
#3
Options

Information

Helpful: 0

Views: 866

Replies: 2

Related Articles