Deco M5 network doesn't allow PC outside subnet to see other computers.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco M5 network doesn't allow PC outside subnet to see other computers.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco M5 network doesn't allow PC outside subnet to see other computers.
Deco M5 network doesn't allow PC outside subnet to see other computers.
2022-02-13 16:09:42 - last edited 2022-02-15 01:44:47
Model: Deco M5  
Hardware Version: V3
Firmware Version: 1.5.3

Greetings.

 

I've just installed a Deco M5 mesh network on my house and It's working perfectly for my wi-fi needs.

However, I have two computers, one is my primary computer that I use for work and games and it's connected directly to the ISP router, at 192.168.0.X subnet.

In my workshop, I have a computer that is connected using the Deco mesh but it's assigned to the 192.168.68.X subnet.

I need to share files between those computers but they can't even see each other in the network.

To add some insult to the injury, one is running Win10 and the other Win7, so the Homegroup options are now disabled by Microsoft.

 

ISP Router ----> PC01 Win10

     \

     M5(router)----M5

           \--M5 -- PC02 Win 07

 

I've tried connecting my PC01 to the M5, but I loose 90% of speed, drops from 650mb to 65mb.

 

                              / ----> PC01 Win10 NO GO

ISP Router----  M5(router)----M5

                              \--M5 -- PC02 Win 07

 

Any suggestions? The workshop is quite far, running a cable is not an option.

Thanks!

  0      
  0      
#1
Options
1 Accepted Solution
Re:Deco M5 network doesn't allow PC outside subnet to see other computers.-Solution
2022-02-13 16:50:21 - last edited 2022-02-15 01:44:47

@CDonini 

 

Configure your Deco to run in Access Point mode: How to set up Deco to work in Access Point mode?

 

This will bring all your devices into single 192.168.0.* subnet and will restore file sharing between your PCs.

Recommended Solution
  4  
  4  
#2
Options
2 Reply
Re:Deco M5 network doesn't allow PC outside subnet to see other computers.-Solution
2022-02-13 16:50:21 - last edited 2022-02-15 01:44:47

@CDonini 

 

Configure your Deco to run in Access Point mode: How to set up Deco to work in Access Point mode?

 

This will bring all your devices into single 192.168.0.* subnet and will restore file sharing between your PCs.

Recommended Solution
  4  
  4  
#2
Options
Re:Deco M5 network doesn't allow PC outside subnet to see other computers.
2022-02-15 01:44:41

  @Alexandre. Thank you! it worked perfectly!

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 669

Replies: 2

Related Articles