No ip on TL-SG1008P
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
No ip on TL-SG1008P
Hello
I have been trying to set up the POE switch in order to power and recieve data from 2 ip cameraes. The problem i am facing is the switch not having any ip adress. When i plug my labtop and cameraes into the switch it will not give an ip adress, however when i plug in an ethernet cable connected to the router i will get an ip adress. Can i not use the POE switch to connect my labtop and cameraes without having the switch hooked up to an ethernet cable with internet?
Best Regards.
Re:No ip on TL-SG1008P
This switch is unmanaged, i.e it won't get any management IP address. It's a plug&play device.
Here's the typical usage:
For non-PoE devices (like your laptop) use a port within range 5-8.
If this was helpful click on the arrow pointing upward to make it blue.
If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".