0% Signal Strength on the status bar

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

0% Signal Strength on the status bar

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
0% Signal Strength on the status bar
0% Signal Strength on the status bar
2022-05-15 14:50:51
Model: TL-MR150  
Hardware Version: V2
Firmware Version: 1.1.0 0.9.1 v0001.0 Build 210803 Rel.55933n

This is my newly bought 4G LTE Wifi Router. The internet connection is slow but it can still load videos in YT but in low resolution. So I explored the . Upon checking on the status bar, it says that the signal strength is 0%. But I'm confused why it said the signal strength is 0% if there is internet passing through it. 

Update: the internet is now a little bit fast, but it still say that the signal strength is 0%

 

What might be the problem?

 

  1      
  1      
#1
Options
1 Reply
Re:0% Signal Strength on the status bar
2022-05-16 01:49:53

  @Akkeyzetsu 

 

Hi, please make sure the LTE antennas are installed properly, if still 0% signal strength, please try to move the device into another location such as near a window to see if the LTE signal would be better.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options

Information

Helpful: 1

Views: 1796

Replies: 1

Related Articles