Damaged while I was updating

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Damaged while I was updating

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Damaged while I was updating
Damaged while I was updating
2022-08-20 15:25:29 - last edited 2022-08-22 00:59:50
Model: Archer MR200  
Hardware Version: V5
Firmware Version:
Hello everything is fine?
When I updated my router, there was a power cut and when I tried to turn on my Archer MR200 again, it didn't work and the blue led just blinks nonstop, I ask for help, it's been 2 months without the equipment working
  0      
  0      
#1
Options
1 Reply
Re:Damaged while I was updating
2022-08-24 12:05:05

  @Edilson01 

 

Hi,really sorry to hear that, it seems the device is bricked due to the power outage during a firmware update.

Please try to reset it to factory defaults by pressing and holding the reset button for about 10s, however, if it still doesn't help, I am afraid you will need to purchase a new one.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 326

Replies: 1

Related Articles