Connecting Deco to router
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have a router with the modem built in. Should I connect the Deco mesh unit to the WAN or LAN port on the router?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Thank you for your reply.
Is this also the case if I set the router to Bridge mode (ie, only the modem will be active in the ISP provided router with all routing left to Deco unit)
- Copy Link
- Report Inappropriate Content
Yes, it is also the case if you will run ISP router in bridge mode. Main Deco must be connected to LAN port of your router/bridge/modem. In that router mode, only one LAN Ethernet port should be active, and it is often first, but not necessarily. If you connect Main Deco to LAN port of a bridge/modem and have no Internet, either check with ISP which LAN port should be active or just try each of them one by one.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 560
Replies: 3
Voters 0
No one has voted for it yet.