NAT Port Forwarding does not work

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

NAT Port Forwarding does not work

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
NAT Port Forwarding does not work
NAT Port Forwarding does not work
2022-11-21 16:02:43
Model: Archer MR200  
Hardware Version: V4
Firmware Version: 1.19.0 0.9.1 v0001.0 Build 210201 Rel.65731n

Hi,

 

I try to set up a NAT connection to an internal host. DDNS setup is done via no-ip and I setup a rule to connect to internal server on port 5100

3 HTTP 443 192.168.0.1 5100 TCP  

 

When I try to connect there is a timeout.

 

Br Stefan

  0      
  0      
#1
Options
1 Reply
Re:NAT Port Forwarding does not work
2022-11-24 12:32:09

  @Oprheus1977 

 

Hi, please check Internet IP address on Advanced->Status page of the MR200 to see if it is a public IP address or private IP address.

If it is a private IP address, it means there is another NAT in the front, if you are using a SIM card for internet access, the NAT is on ISP side, in that case, you will need to contact the ISP to see if they could assign you a public IP address.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 478

Replies: 1

Related Articles