Archer MR200 hw v5.3 - error 1

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer MR200 hw v5.3 - error 1

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer MR200 hw v5.3 - error 1
Archer MR200 hw v5.3 - error 1
2022-12-14 09:53:42 - last edited 2022-12-14 09:57:03
Model: Archer MR200  
Hardware Version: V5
Firmware Version: V1

All subsystem was working ok.
After switching "Operation Mode" from "3G/4G Router Mode" to "Wireless Router Mode" and reboot, 

SIM card is not work and web gui have error on every page:

 

Error code: 1
Internal error.

 

 

 

I was try to reset it to factory default, and this error is repeated.

On site, support download, I can't found a any firmware for hw v5.3?

 

Where I can download firmware for hw v5.3?

 

File:
2022-12-14_11-32-20_1025x576_selection.pngDownload
  0      
  0      
#1
Options
5 Reply
Re:Archer MR200 hw v5.3 - error 1
2022-12-16 14:54:53

  @LArV 

Hi, may I know how the issue started happening? and what is your current firmware version?

 

In addition, the MR200 V5.3 firmware has been available on official website:

https://www.tp-link.com/en/support/download/archer-mr200/v5.3/#Firmware

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options
Re:Archer MR200 hw v5.3 - error 1
2022-12-16 18:09:28

  @Sunshine 

Thanks for firmware.

I try upgrade over web interface, but after showing the dialog of upload firmware on 100% and wait reboot, see message:

Error code: 71211
Failed to upload upgrade file. Please select the correct file.

Can I upgrade firmware by alternative tools (I working on arch linux): curl, tftp, etc?

  0  
  0  
#3
Options
Re:Archer MR200 hw v5.3 - error 1
2022-12-19 06:58:04

  @LArV 

 

Sorry, the MR200 doesn't support firmware recovery via other tools, may I know the current firmware version of your MR200?

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#4
Options
Re:Archer MR200 hw v5.3 - error 1
2023-05-13 15:11:08

  @Sunshine 

 

Hi! I have the same problem. I have an Archer MR200 v5.3, firmware: 1.0.0.0.9.1 v0001.0 Build 210226 Rel.59749n

 

I get the same error when I try to update to the newest firmware

  0  
  0  
#5
Options
Re:Archer MR200 hw v5.3 - error 1
2023-05-15 03:28:02

  @Giova104 

 

Hi, your current firmware is for V5.20, may I know if you installed V5.20 firmware on your V5.30 product?

 

Please try to reset it to factory defaults by holding reset button for about 10s until power LED starts flashing, then please try to update the V5.30 firmware again, try the two firmware for V5.30 on our official website one by one.

 

If either of them works, I am afraid previous wrong firmware update has damaged the product, you will need to contact the retailer where you bought it to check warranty, 

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#6
Options

Information

Helpful: 0

Views: 737

Replies: 5

Related Articles