Open nat
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi guys
What settings please do I put in port forwarding on add rule on one of my M4's wired to a xbox please
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Have you got "Double NAT detected" error message on XBOX? In that case, the solution is to configure Deco mesh run in Access Point mode: How to set up Deco to work in Access Point mode
- Copy Link
- Report Inappropriate Content
@Alexandre. Yes exactly
- Copy Link
- Report Inappropriate Content
Will I get the same fast speeds as a AP?
Always used it default non AP
Can I use just one of the M4's as a AP
- Copy Link
- Report Inappropriate Content
You will get the same WiFi speeds.
This configuration change applies to Deco mesh, not to individual Deco units. After you follow steps from the document I shared your Deco mesh, all its units, will run in Access Point mode.
If you find issues with running Deco mesh in Access Point mode, you can easily revert it back to its default Router mode.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 651
Replies: 4
Voters 0
No one has voted for it yet.