Range extender not working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Range extender not working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Range extender not working
Range extender not working
2023-07-26 21:33:40
Model: RE305  
Hardware Version: V3
Firmware Version:

My wifi has both 2.4g and 5g. So when I tried to get the range extender set up through the app, at first, only the 2.4g extender worked. In efforts to get the 5g to work, I factory reset it and tried the set up again. This time, I can't connect to the extenders wifi, even after I reset the password through the app. No matter what I did, only the power LED lit up, never the signal, 2.4G, or 5G LEDs. Does anyone have a solution?

  0      
  0      
#1
Options
1 Reply
Re:Range extender not working
2023-07-28 09:37:09 - last edited 2023-07-28 09:43:34

  @Phokus-5 

 

Hi, after factory reset, the default extender Wi-Fi should be open, no password required. Please reset the extender again: Use a pin to press the reset button/hole for 1 second, then please refer to the instructions below to configure it:
Via Tether App: https://www.tp-link.com/support/faq/1373/

Via Web interface: https://www.tp-link.com/support/faq/1400/

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 560

Replies: 1

Related Articles