Unable to connect to my router
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi folks
I have been trying to setup my RE315 and it's driving my bonkers! I initially tried using the webUI and I could see the RE and connect to it but when I went through the process of putting in my WiFi details the only light that was visible was the power light at the end of the process. So I thought I'd try the tether app. I was able to successfully go through the process and the power/WiFi/2.4Ghz lights were on and I confirmed I had Internet access. Next I unplugged it and moved it to the desired location but when I plugged it in only the power light was active, as if it had lost all of its settings. When I connected via the tether app even though the details were it was as if it had lost its connection to the router. I have subsequantly done a reset using the tether interface and the hard reset button and have been unable to get it to connect to the router and it only shows the power light solid.
Am I missing something here?
Cheers!
Yes, this would be a good test. Just make sure you have successfully reset the device:
Directly press and hold the reset button on the side panel with a solid pin for approximately 1 to 2 seconds when the device is powered on. If you can see all the lights flashing, then go off and some lights go back on slowly, that means the device has been reset successfully.
Follow this FAQ if you still failing to configure the RE.
Follow this FAQ if you can't see the SSID of the RE after configuration.
Follow this FAQ for how to boost youe Wi-Fi signal.
Yes, this would be a good test. Just make sure you have successfully reset the device:
Directly press and hold the reset button on the side panel with a solid pin for approximately 1 to 2 seconds when the device is powered on. If you can see all the lights flashing, then go off and some lights go back on slowly, that means the device has been reset successfully.
Follow this FAQ if you still failing to configure the RE.
Follow this FAQ if you can't see the SSID of the RE after configuration.
Follow this FAQ for how to boost youe Wi-Fi signal.