Home Network Community > All Threads > Deco X50 network not found by clients
< All Threads

Deco X50 network not found by clients

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco X50 network not found by clients

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco X50 network not found by clients
Deco X50 network not found by clients
2024-03-24 20:40:20 - last edited 2024-03-25 02:46:25
Model: Deco X50  
Hardware Version:
Firmware Version: 1.4.1

All of a sudden my home network cannot be seen by my wireless clients.  

 

Everything is going through my ISP's modem at the moment, which is not what I want.

 

Have rebooted the Deco unit and still no luck, somewhat at a loss so any help is greatly appreciated.

 

TIA

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:Deco X50 network not found by clients-Solution
2024-03-24 23:47:46 - last edited 2024-03-25 02:46:25
Ok, after some digging around on the Deco web interface I found out that for some reason the setting that allowed that Home network to be " seen" by the clients was switched off. Not sure why this happened but it may help. This is found under the Advanced | Status | Wireless Enabled should be set to "ON"
Recommended Solution
  1  
  1  
#3
Options
2 Reply
Re:Deco X50 network not found by clients
2024-03-24 21:09:12

Ok so I tried the following:

 

I set up a guest network within my home network and am now able to connect to the Deco unit, not really sure what is going on at this point. Thought i would share

  0  
  0  
#2
Options
Re:Deco X50 network not found by clients-Solution
2024-03-24 23:47:46 - last edited 2024-03-25 02:46:25
Ok, after some digging around on the Deco web interface I found out that for some reason the setting that allowed that Home network to be " seen" by the clients was switched off. Not sure why this happened but it may help. This is found under the Advanced | Status | Wireless Enabled should be set to "ON"
Recommended Solution
  1  
  1  
#3
Options

Information

Helpful: 0

Views: 469

Replies: 2

Related Articles
Guest network not working with Deco X50 connected to Deco X50-4G
985 2
Deco X50 Outdoor no IoT network
927 1
Expand Deco X50 network
845 0
Deco X50 upgrade
512 0
Backhaul on Deco X50
319 0
Deco X50-5G after setup wants me to login to a network
166 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.