M7300 fail to start after upgrade

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

M7300 fail to start after upgrade

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
M7300 fail to start after upgrade
M7300 fail to start after upgrade
2024-04-11 01:12:48
Model: M7300  
Hardware Version: V3
Firmware Version: 1.0.18 Build 181220 Rel. 1068n

after upgrade to latest version downloaded, it reboot and the battery light bliking, never able to start.

even with battery on. anyone can help?

  0      
  0      
#1
Options
2 Reply
Re:M7300 fail to start after upgrade
2024-04-12 02:04:42

  @LimLim 

 

If your Mobile Wi-Fi device fails to boot up and gets stuck on the TP-Link logo during initialization, here are some troubleshooting steps you can try:

1. Reset the MiFi device: Hold the reset hole for approximately 10 seconds.

2. Remove the battery, reinsert it, and attempt to turn on the device again.

 

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options
Re:M7300 fail to start after upgrade
2024-04-12 03:40:12

  @Sunshine I have tried reset, also the same. Battery light blinking once I power on, even if I hold reset button for more than 10 seconds. Plug into pc, device manager shows android device.

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 355

Replies: 2

Related Articles