ER605 and AX 72 in router mode, on the same gateway
Hello,
I have a Omada ER605 and an AX 72 router.
I would like ER605 to work as the main router, but also need AX72 to work in Router mode, for the EasyMesh capabilities (so far, I have not seen EasyMesh being available in AP mode yet).
The problem is that when I connect ER605 LAN to AX72 WAN, the router changes ip from 192.168.0.2 to 192.168.1.1 and as such, everything connected to the router gets an 192.168.1.x IP address.
In ER605 I have given AX72 192.168.0.2 IP, and disabled DHCP on AX72, but I am still having this issue where it either changes IP, or no connected devices have internet.
I realize this is a newbie question, but I cannot seem to find any proper instructions on how to set this up on the AX72, to work as expected.
Has anybody been able to configure this?
@Madalinbv Im using er605 +(ax23+ax23+c64 (onemesh))
Do like i did: and everything will work:
ENABLE DHCP on AX72 .
ON ax72 web interface just set get WAN ip automatically so your AX72 will get WAN IP 192.168.6.2
PS If you wish add ax72 to Address Reservation.
