WDR4300 troubles with print server and Canon ip2770
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
WDR4300 troubles with print server and Canon ip2770
Region : Indonesia
Model : TL-WDR4300
Hardware Version : V1
Firmware Version : 3.13.31 Build 130319 Rel.57876n
ISP : Telkom Speedy
Just got this modem and was unsuccessful in getting to the printer I had connected to the print server. I'm on Win 7 64 bit. Previously this printer (Canon ip2770) was attached to this computer and worked fine (still does now that I put it back there). I was able to successfully (so it seemed) installed and it was visible in the Print Server Controller, with all appearing normal. But Win 7 cannot find the printer at all, even when I looked for it at the server's IP. Nothing there.
I tried rebooting, reinstalling the printer and print server controls and still the same. I see that the "approved list" does NOT include Canon ip 2770, but it does include other "nearby" models, e.g. ip2780, which are pretty much the same. BTW, I got storage sharing working fine.
Any ideas as to how to get this to work correctly?
Model : TL-WDR4300
Hardware Version : V1
Firmware Version : 3.13.31 Build 130319 Rel.57876n
ISP : Telkom Speedy
Just got this modem and was unsuccessful in getting to the printer I had connected to the print server. I'm on Win 7 64 bit. Previously this printer (Canon ip2770) was attached to this computer and worked fine (still does now that I put it back there). I was able to successfully (so it seemed) installed and it was visible in the Print Server Controller, with all appearing normal. But Win 7 cannot find the printer at all, even when I looked for it at the server's IP. Nothing there.
I tried rebooting, reinstalling the printer and print server controls and still the same. I see that the "approved list" does NOT include Canon ip 2770, but it does include other "nearby" models, e.g. ip2780, which are pretty much the same. BTW, I got storage sharing working fine.
Any ideas as to how to get this to work correctly?