WDR 4300 Jumbo Frame support
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
WDR 4300 Jumbo Frame support
Region : Ireland
Model : TL-WDR4300
Hardware Version : V1
Firmware Version : latest
ISP :
I have just acquired a Synology DS414 NAS and have enabled jumbo frame support on it, but cannot get it to work through the switch ports on my WDR4300.
If I connect my main PC and the NAS through a spare 5-port Netgear switch I have, it works perfectly, so both my PC (with Realtek 8168 GigE chipset) and the Synology NAS clearly support jumbo frames properly.
As soon as I connect them through the TP-Link router it stops working. I have tried all the possible MTU values, but no luck.
So, does the WDR4300 really support jumbo frames? Has it actually been tested at all?
Model : TL-WDR4300
Hardware Version : V1
Firmware Version : latest
ISP :
I have just acquired a Synology DS414 NAS and have enabled jumbo frame support on it, but cannot get it to work through the switch ports on my WDR4300.
If I connect my main PC and the NAS through a spare 5-port Netgear switch I have, it works perfectly, so both my PC (with Realtek 8168 GigE chipset) and the Synology NAS clearly support jumbo frames properly.
As soon as I connect them through the TP-Link router it stops working. I have tried all the possible MTU values, but no luck.
So, does the WDR4300 really support jumbo frames? Has it actually been tested at all?
