TP-W8970 IPSec configuration
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TP-W8970 IPSec configuration
Region : Argentina
Model : TD-W8968
Hardware Version : V3
Firmware Version :
ISP :
Hello,
I'm trying to do IPSec VPN on my TP-Link router but i have problem with it. I can explain it Internet is not free -as in freedom- anymore and government do MITM to DNS queries and HTTP traffic etc. I just wana do IPSec tunnels to a server which is located in Amsterdam but i have a little problem.
On Vyatta and lots of routers you can use NATed traffic over IPSec tunnels but TP-Link's UI doesn't allow to me type remote ip as 0.0.0.0 and says "Remote IP address is invlaid" http://prntscr.com/37hppc Is it impossible to use NATed traffic over IPSec VPN on it? Or Do you have any how-to guide for it. I tried to find it in your documentations bur couldn't find it
Thanks a lot
Levent
Model : TD-W8968
Hardware Version : V3
Firmware Version :
ISP :
Hello,
I'm trying to do IPSec VPN on my TP-Link router but i have problem with it. I can explain it Internet is not free -as in freedom- anymore and government do MITM to DNS queries and HTTP traffic etc. I just wana do IPSec tunnels to a server which is located in Amsterdam but i have a little problem.
On Vyatta and lots of routers you can use NATed traffic over IPSec tunnels but TP-Link's UI doesn't allow to me type remote ip as 0.0.0.0 and says "Remote IP address is invlaid" http://prntscr.com/37hppc Is it impossible to use NATed traffic over IPSec VPN on it? Or Do you have any how-to guide for it. I tried to find it in your documentations bur couldn't find it
Thanks a lot
Levent