Bricked WR842ND?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Bricked WR842ND?
Region : Argentina
Model : TL-WR1043ND
Hardware Version : V2
Firmware Version :
ISP :
Hi!
I hope I can get some advise here...
I decided to change my firmware by updating to dd-wrt as I wanted to have a repeater's mode... Eventually, it didn't prove to be as good as I expected, thus made up my mind to get back to a factory firmware... After several attempts to remove dd-wrt I made a stupid thing.. I deleted linux through telnet and rebooted by router! Now when I turn it on all leds are just flashing and that's it :(
When press RST button the "locksmith led" goes on and it seems that I connected to my router via ethernet cable, but I cannot ping it nor find another way how I can connect to it in order to upload a right firmware file...
Any help?
Model : TL-WR1043ND
Hardware Version : V2
Firmware Version :
ISP :
Hi!
I hope I can get some advise here...
I decided to change my firmware by updating to dd-wrt as I wanted to have a repeater's mode... Eventually, it didn't prove to be as good as I expected, thus made up my mind to get back to a factory firmware... After several attempts to remove dd-wrt I made a stupid thing.. I deleted linux through telnet and rebooted by router! Now when I turn it on all leds are just flashing and that's it :(
When press RST button the "locksmith led" goes on and it seems that I connected to my router via ethernet cable, but I cannot ping it nor find another way how I can connect to it in order to upload a right firmware file...
Any help?
Print screen
Hi!
Please find a printscreen attached!
I am not sure if I have a well established connection. Most likely not, because I am unable to connect. My assumption was based on a fact that when I pushed RESET button my PC stops looking for a connection (and reminding 'cable unplugged') and just shows that it is connected (under "Network connections").
Thank you for helping me!
