Region : UnitedKingdom

Model : TL-WR702N

Hardware Version : V1

Firmware Version :

ISP :

Hi,

I have several WR702N's and need really short dhcp lease times, ideally 30 seconds or so but the options only allow me to go to 1 minute, I have tried setting the lease times to this but no matter what the setting in the AP anything connecting even up to a couple of hours later still gets the same IP, the setup I am using is as follows

1 * WR702N as an access point
5 * WR702N as clients

only three of the clients are in use at any one time and if I disconnect one from the network and wait 2 minutes I need the new client to grab the IP of the removed device, no matter what I set the dhcp lease time too it's holding IP's for hours and stopping this from happening.

Any ideas?


pod