Configure a default route without using WAN

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Configure a default route without using WAN

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Configure a default route without using WAN
Configure a default route without using WAN
2014-07-25 01:45:10
Region : Brazil

Model : Archer C7

Hardware Version : Not Clear

Firmware Version : 3.13.34 Build 140402

ISP : NET


Guys,

Is there any possibility to input a "default route" to a another network device inside the LAN, I mean, without using WAN side?

My LAN subnet is 192.168.10.0 /24 and I need to configure a default route to an IP 192.168.10.2 for instance.

I tried to input:

Destination Network: 0.0.0.0
Subnet Mask: 0.0.0.0
Default Gateway: 192.168.10.2
Status: Enabled

The asnwer from the router was:

Error code: 4001
Bad destination IP address, please input another one.

I ´ve already handle many others router and there I´m able to do that.

What about this Archer 7, is it possible? As a router it have to be possible!!!

Tks

Hortolani
  0      
  0      
#1
Options
1 Reply
Re:Configure a default route without using WAN
2014-07-31 10:32:19
You should realized that what you buy is a NAT router for SOHO applications, mainly for internet sharing for private networks. But your requirement can only be meet with a "traditional router", whcih usaully route between subnets.

Buy a cisco enterprise router. Or flash a openwrt and set up the desired router based on linux
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 680

Replies: 1

Related Articles