cant access TP-LINK W8961-ND gateway
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
cant access TP-LINK W8961-ND gateway
Region : Australia
Model : TD-W8968
Hardware Version :
Firmware Version : V2 - latest firmware
ISP :
Hello All,
I have a TP-LINK W8961-ND and I cannot seem to access the default gateway either via wireless or ethernet cable.
If I go to my default gateway nothing happens the page will not load at all...... If I turn the power off to the modem and turn it back on I gain a small window around 15 secodns where I can access the modeme settings and make changes.... then it stops working again.
If I do a hard reset on the modem it works perfectly again for the first setup.......
I have also tried changing the default gateway... though since updating to latest firmware it WILL not save the page if I try to change my default gateway to something else....
I have also tried an isolation test....... plugging in only 1 device and trying to connect,
Why can't I access my default gateway on demand? why must I reboot the router and muck around trying to gain access to it's settings? is there something I'm not doing correctly??
Thanks
Model : TD-W8968
Hardware Version :
Firmware Version : V2 - latest firmware
ISP :
Hello All,
I have a TP-LINK W8961-ND and I cannot seem to access the default gateway either via wireless or ethernet cable.
If I go to my default gateway nothing happens the page will not load at all...... If I turn the power off to the modem and turn it back on I gain a small window around 15 secodns where I can access the modeme settings and make changes.... then it stops working again.
If I do a hard reset on the modem it works perfectly again for the first setup.......
I have also tried changing the default gateway... though since updating to latest firmware it WILL not save the page if I try to change my default gateway to something else....
I have also tried an isolation test....... plugging in only 1 device and trying to connect,
Why can't I access my default gateway on demand? why must I reboot the router and muck around trying to gain access to it's settings? is there something I'm not doing correctly??
Thanks