Not working after trying to upgrade

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Not working after trying to upgrade

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Not working after trying to upgrade
Not working after trying to upgrade
2015-03-17 19:27:04
Region : Netherlands

Model : TL-WPA4220

Hardware Version : V1

Firmware Version :

ISP :


After trying to upgrade to 140401, it stopped working. Tried to reset to factory settings, but also didn't work.

What to do?
  0      
  0      
#1
Options
4 Reply
Re:Not working after trying to upgrade
2015-03-18 16:21:16
No lights at all? What's the problem indeed?
  0  
  0  
#2
Options
Re:Not working after trying to upgrade
2015-03-19 22:02:54
Lights are working, but can not connect to the powerline. It also doesn't got a connection to the internet. Tried to pair it again, didn't work.
  0  
  0  
#3
Options
Re:Not working after trying to upgrade
2015-03-20 13:56:33
Do your mean powerline light is off?
You got two? PA4010 and WPA4220?
Run the utility for PA4010 and reset both of them. After reset, check if powerline light will be on. Or try to set the same network name for both of them.
  0  
  0  
#4
Options
Re:Not working after trying to upgrade
2015-03-23 19:24:58
The PA4010 is working correct I guess. I just can't connect to the WPA4220.

- All the lights are working;
- In my network list on PC it says: TP-LINK_etc. etc.;
- Tried to pair, didn't work;
- Happend after I tried to upgrade my firmware of the WPA4220.
  0  
  0  
#5
Options