W8951ND ADSL Initialize problem

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

W8951ND ADSL Initialize problem

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
W8951ND ADSL Initialize problem
W8951ND ADSL Initialize problem
2015-06-10 05:05:38
Region : Egypt

Model : TD-W8968

Hardware Version : V4

Firmware Version :

ISP :


Hi,
I have the TD-W8951ND ADSL router. Suddenly it stopped ADSL connection. Tried factory reset, reset switch, and 30/30/30 reset but no success. Tried with 2 different providers where their VPI/VCI 0/35 and connection is PPPoE/PPPoA and LLC encapsulation but nothing changed. The ADSL LED only blinks for 2 or 3 times every 30 seconds or so and the ADSL State Activation or Initializing then down and nothing changes too. I disabled UPnP and ACL but no hope also. I also flashed different firmwares from 140226 till 141114 for V5 hardware. If I unplug the ADSL line the ADSL LED stays off forever and blinks as stated earlier only when I plug the ADSL line again. Line is connected directly and dedicated for the router. No splitter.
  0      
  0      
#1
Options
1 Reply
Re:W8951ND ADSL Initialize problem
2015-06-10 11:49:24
Did you contact your ISP to test the line?
Go to Advanced Setup---ADSL, change ADSL Mode to ADSL2 or G.DMT.
If ADSL light still keeps flashing intead of solid on with telephone line plugged in, may be the modem is faulty.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 1151

Replies: 1

Related Articles