TD-8840T Can't enable DHCP
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TD-8840T Can't enable DHCP
Region : Others
Model : TD-8840T
Hardware Version : V4
Firmware Version : 2.0.1 Build 100525 Rel.13188
ISP :
Hi everyone.
I have a TP-Link 8840T with the latest firmware. V = 2.24 which should be V2.
A couple of hours ago I disabled DHCP because of a device that I wanted to try and now I am trying to enable it again but for some reason I can't.
I go to: Interface Setup-> LAN
DHCP is disabled so I click the radio box Enabled.
Then the page is refreshed and the DHCP table appears, there is nothing to enter there so i just leave it. I then try to click on Save but the MAC address field of the DHCP get's filled with 00:00:00:00:00 and nothing happens. So I click again on Save and nothing :confused: How come? I just can't get it to save the config and DHCP does not get enabled.
Any ideas?
Best Regards,
Model : TD-8840T
Hardware Version : V4
Firmware Version : 2.0.1 Build 100525 Rel.13188
ISP :
Hi everyone.
I have a TP-Link 8840T with the latest firmware. V = 2.24 which should be V2.
A couple of hours ago I disabled DHCP because of a device that I wanted to try and now I am trying to enable it again but for some reason I can't.
I go to: Interface Setup-> LAN
DHCP is disabled so I click the radio box Enabled.
Then the page is refreshed and the DHCP table appears, there is nothing to enter there so i just leave it. I then try to click on Save but the MAC address field of the DHCP get's filled with 00:00:00:00:00 and nothing happens. So I click again on Save and nothing :confused: How come? I just can't get it to save the config and DHCP does not get enabled.
Any ideas?
Best Regards,
