Configure NAT
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Configure NAT
Model :
Hardware Version : Not Clear
Firmware Version :
ISP :
Hi,
I just setup my NS600 W8980 and its all pretty good but I have no clue on how should I port forward in a particular scenario.
/.
So I have a static IP address and 2 computers working home, one of them (192.168.1.3) is running CentOS and I would like to run some tests so I would like to be able to browse port 80 on that machine from the outside (?)
How can I accomplish such task?
regards.
Hardware Version : Not Clear
Firmware Version :
ISP :
Hi,
I just setup my NS600 W8980 and its all pretty good but I have no clue on how should I port forward in a particular scenario.
/.
So I have a static IP address and 2 computers working home, one of them (192.168.1.3) is running CentOS and I would like to run some tests so I would like to be able to browse port 80 on that machine from the outside (?)
How can I accomplish such task?
regards.