Disabling NAT in TL-WR940N

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Disabling NAT in TL-WR940N

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Disabling NAT in TL-WR940N
Disabling NAT in TL-WR940N
2015-10-01 03:19:25
Model : TL-WR940N

Hardware Version : V1

Firmware Version : 3.13.9 Build 120201 Rel.54965n

ISP :

Hello,
I can't find the option to disable NAT at TL-WR940N, is this possible? (I don't want to disable DHCP)
  0      
  0      
#1
Options
3 Reply
Re:Disabling NAT in TL-WR940N
2015-10-08 13:36:51
No...no such an option...
  0  
  0  
#2
Options
Re:Disabling NAT in TL-WR940N
2015-10-08 18:42:29
Thanks!
  0  
  0  
#3
Options
Re:Disabling NAT in TL-WR940N
2020-10-06 17:37:06 - last edited 2020-10-06 17:39:07

@nadacohe @All

 

I have the same issue. So we cannot disable NAT? I have FW acting as the WAN gateway, where I got the TL-WR940N to serve as the LAN wireless in a trust zone.

I wanted to have all wireless users receiving IP address via DHCP from the Tp_link and whole traffic be Natted only at my FW Gateway. However, even with the TP-link firewall disabled, it seems I cannot turn off NAT on it.

In the Working Mode section, seems that it requires the Access Point mode, but it is not working.

 

Could you confirm this? I want the TP-link acting as simple wireless concentrator and router (NO NAT). The issue I have is that all devices reaches the FW with the WAN TP-link IP address, so unless deploying User-ID or any other sofisticated technique, it is difficult to track the session per user in the Firewall Gateway.

 

Could you please clarify this to me?

 

Thanks a lot

  0  
  0  
#4
Options

Information

Helpful: 0

Views: 2417

Replies: 3

Related Articles