UPNP & SNP not working after a while on TD-W8961ND
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
UPNP & SNP not working after a while on TD-W8961ND
Model : TD-W8961ND
Hardware Version : V3
Firmware Version : Build 141023 Rel.24209
ISP : PLDT
Hi,
On my TD-W8961ND, UPNP and SNMP stops working after a while (I have both enabled). It always happens 100% of the time when I shut off the computer and resume after a few hours. I have to turn the router on/off for UPNP to get working again.
It seems that UPNP/SNMP is also affected when management interface became inaccessible (the so called "security feature"). But in my case, not only is router interface not accessible, but also UPNP & SNMP which should not be the case.
Is there a firmware upgrade for this? Can't seem to find one. If there isn't they I will have this returned since this is basically broken.
Hardware Version : V3
Firmware Version : Build 141023 Rel.24209
ISP : PLDT
Hi,
On my TD-W8961ND, UPNP and SNMP stops working after a while (I have both enabled). It always happens 100% of the time when I shut off the computer and resume after a few hours. I have to turn the router on/off for UPNP to get working again.
It seems that UPNP/SNMP is also affected when management interface became inaccessible (the so called "security feature"). But in my case, not only is router interface not accessible, but also UPNP & SNMP which should not be the case.
Is there a firmware upgrade for this? Can't seem to find one. If there isn't they I will have this returned since this is basically broken.
