TL-WA901ND system led blinking after reset, no network
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-WA901ND system led blinking after reset, no network
Model :
Hardware Version : Not Clear
Firmware Version :
ISP :
Hello,
I have a TL-WA901ND and I was using it as a repeater.
Yesterday, I wanted to configure it as a router. I accessed the router through the browser and changed its IP.
After the system reboot, the system led wouldn't stop blinking (+- 1Hz), and I could not connect to the router network (I tried using wireless and cable).
I then tried resetting it, and got the same result - system led blinking, I can see the router setup wireless network, but I cannot connect to it (wireless or cable).
I tried checking the results from ipconfig, and I haven't been given an IP for the network. I've also tried using arp -a to check the connected devices in the network, but there were none.
Coincidentally, I have also got a TL-WR702N, and I'm having exactly the same problem after I reset it - cannot connect to the network. The only difference is, this router hasn't got a system led.
I've tried using two other computers to connect to the routers, with no success.
Thanks in advance.
Hardware Version : Not Clear
Firmware Version :
ISP :
Hello,
I have a TL-WA901ND and I was using it as a repeater.
Yesterday, I wanted to configure it as a router. I accessed the router through the browser and changed its IP.
After the system reboot, the system led wouldn't stop blinking (+- 1Hz), and I could not connect to the router network (I tried using wireless and cable).
I then tried resetting it, and got the same result - system led blinking, I can see the router setup wireless network, but I cannot connect to it (wireless or cable).
I tried checking the results from ipconfig, and I haven't been given an IP for the network. I've also tried using arp -a to check the connected devices in the network, but there were none.
Coincidentally, I have also got a TL-WR702N, and I'm having exactly the same problem after I reset it - cannot connect to the network. The only difference is, this router hasn't got a system led.
I've tried using two other computers to connect to the routers, with no success.
Thanks in advance.