Good afternoon!

During the firmware update of the microcontroller, my RE360 v.1 turned into a brick...

There is no way to get into its shell either by IP address or through a link. When the voltage is applied, the light circle around the WPS button turns pink (red) for a few seconds and goes out.

The POWER indicator is blue and it does not respond to button clicks.

It also does not respond to pressing the RESET button.

At the same time, I noticed an interesting feature - if you do not touch the device for a few minutes after turning it on, it allows you to press the POWER button once and reboot, after which nothing will happen again.

I also noticed that if you connect to the device via cable and set the IP address 192.168.0.254 in the network adapter settings, you will see that packets are being exchanged.

I tried to restore it through the Tftpd64 program, but I can't create a connection.

I tried setting IP addresses - 192.168.0.66, 192.168.0.68, 192.168.0.86, 192.168.0.254

But no connection was established.

What are my questions about?

What is the correct recovery IP address for RE360 v.1?

What is the correct name for the recovery file (re360v1_tp_recovery.bin or just tp_recovery.bin)?

I would be eternally grateful for any help, advice, or recommendations.