? Archer MR200 - Cannot change Region / Select different channel
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
? Archer MR200 - Cannot change Region / Select different channel
Archer MR200 - Firmware:0.9.1 0.0 v004a.0 Build 160412 Rel.38588n - Hardware:Archer MR200 v1 00000001
Firmware Version : 0.9.1 0.0 v004a.0 Build 160412 Re
ISP :
Hi,
I previously used a MR200 and was able to select the region?
This does no seem possible on the Archer MR200 I am currently using?
Is there a way of getting to the region setting some how? I would like to use one of the 5GHz cannels that is not 36, 40, 44 or 48 and currently I can only select these 4 channels.
I have tried downloading the firmware from the website, but it will not install?
Any help appreciated.
Firmware Version : 0.9.1 0.0 v004a.0 Build 160412 Re
ISP :
Hi,
I previously used a MR200 and was able to select the region?
This does no seem possible on the Archer MR200 I am currently using?
Is there a way of getting to the region setting some how? I would like to use one of the 5GHz cannels that is not 36, 40, 44 or 48 and currently I can only select these 4 channels.
I have tried downloading the firmware from the website, but it will not install?
Any help appreciated.