VR600 and Bandwidth Control
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
VR600 and Bandwidth Control
Model :
Hardware Version :
Firmware Version :
ISP :
I have a TP-Link Archer VR600 hooked up to a Wireless broadband service that provides 25Mbps down 10Mbps up, the modem for this is connected to the WAN port on the router. Speedtest.net shows that these speeds are consistently achieved.
I want to use Bandwidth Control to reserve some bandwidth for several simultaneous VoIP calls.
Having done that I would expect that a speedtest carried out on a different IP address would get 23Mbps down as I have reserved two segments of 1000Kbps each. Can anyone explain why a speedtest with this enabled only shows a download capacity of 10Mbps, I have lost 15Mbps rather than the expected 2Mbps.
As an FYI devices for the specified IP addresses are not yet connected to the network as I'm looking at isolating the issue.
Hardware Version :
Firmware Version :
ISP :
I have a TP-Link Archer VR600 hooked up to a Wireless broadband service that provides 25Mbps down 10Mbps up, the modem for this is connected to the WAN port on the router. Speedtest.net shows that these speeds are consistently achieved.
I want to use Bandwidth Control to reserve some bandwidth for several simultaneous VoIP calls.
Having done that I would expect that a speedtest carried out on a different IP address would get 23Mbps down as I have reserved two segments of 1000Kbps each. Can anyone explain why a speedtest with this enabled only shows a download capacity of 10Mbps, I have lost 15Mbps rather than the expected 2Mbps.
As an FYI devices for the specified IP addresses are not yet connected to the network as I'm looking at isolating the issue.
File:
bandwidth.pngDownload