Routing issue - WR841N v12

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Routing issue - WR841N v12

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Routing issue - WR841N v12
Routing issue - WR841N v12
2017-06-06 20:09:28
Model :

Hardware Version :

Firmware Version :

ISP :

I have connected a WR841n router to an ISP modem (routing mode), however, I cannot connect to the internet. However, hooking my PC to the ISP modem, I can.
Accessed tehrouter via port 80, and after troubleshooting, found out the following:
1- System routing table shows the following: 0.0.0.0 mask 255.255.255.255 Gateway = WAN IP address (should not

I have tried adding a default route - 0.0.0.0 mask 0.0.0.0 Gateway = WAN ip Address, however, the router gave me an error message, and default route is not added.
Adding a specific route - example - 216.0.0.0 mask 255.0.0.0 gateway = WAN IP Address worked fine, and I could access all sites within these IP addresses.

How to fix this issue, knowing that I have tried resetting the Router to Factory default, with no success?
I still need to use this router - as a router and not as a bridge (which may resolve the issue of the default router is I decide to do so)

best regards
  0      
  0      
#1
Options
1 Reply
Re:Routing issue - WR841N v12
2017-07-21 16:56:32
have you tried a firmware upgrade?
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 508

Replies: 1

Related Articles