No connection after changing IP adress
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
No connection after changing IP adress
Model :
Hardware Version :
Firmware Version :
ISP :
HI there
I have an Archer D20 which I want to set up as a WAP. The only thing I do is to change the IP address from 192.168.1.1 to one in the 192.168.0.xxx range, save and reboot. This makes the router inaccessible and I cannot reconnect. I can reset it using the WPS button at the back and then it is accessible at 192.168.1.1 again.
When doing the change as described above, my PC is connected only to the router with all other connections disabled.
Any advice would be great.
Paul
Hardware Version :
Firmware Version :
ISP :
HI there
I have an Archer D20 which I want to set up as a WAP. The only thing I do is to change the IP address from 192.168.1.1 to one in the 192.168.0.xxx range, save and reboot. This makes the router inaccessible and I cannot reconnect. I can reset it using the WPS button at the back and then it is accessible at 192.168.1.1 again.
When doing the change as described above, my PC is connected only to the router with all other connections disabled.
Any advice would be great.
Paul
