Virtual Server set-up on L-MR3420 wireless N Router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Virtual Server set-up on L-MR3420 wireless N Router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Virtual Server set-up on L-MR3420 wireless N Router
Virtual Server set-up on L-MR3420 wireless N Router
2017-07-29 13:42:39
Model : TL-MR3420

Hardware Version :

Firmware Version : 3.16.9 Build 160412 Rel 45197n

ISP : Optus

In setting up some Virtual server connections in the router the user guide Pgae45 says to ensure that NAT is enabled
I cannot find this parameter in any of the entries to check if it is enabled or not?

Please indicate where to find it so I may check its staus

Also for the Virtual server changes does the router have to be rebooted?

Thank you for any assistance you can provide
  0      
  0      
#1
Options
1 Reply
Re:Virtual Server set-up on L-MR3420 wireless N Router
2017-08-01 16:32:12
For the NAT, it is enabled by default as long as you use this as a router, i.e. get internet from 3G/4G modem or by connecting your ISP to the WAN port.
About the reboot, mostly it is needed. The TP-Link setup page will remind you if it is necessary.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 504

Replies: 1

Related Articles