Archer VR2800 OpenVPN Issue
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer VR2800 OpenVPN Issue
Model :
Hardware Version :
Firmware Version :
ISP :
Hi Guys,
I've just picked up a VR2800 and have been playing with the OpenVPN feature.
I completed the configuration and exported the file to my Mac.
The VPN connects and I can ping the default address of the VR2800 [192.168.1.1].
However I cannot reach anything else on the inside of my network.
I'm using the default address scheme for the LAN side of the router and the default for the VPN being...
192.168.1.0/24 LAN and 10.8.0.0/24 VPN
As there is very little means to debug what is going on here could anyone have a guess at what is happening here.
On the MAC I have used both TunnelBlick and Viscosity OpenVPN clients.
Hardware Version :
Firmware Version :
ISP :
Hi Guys,
I've just picked up a VR2800 and have been playing with the OpenVPN feature.
I completed the configuration and exported the file to my Mac.
The VPN connects and I can ping the default address of the VR2800 [192.168.1.1].
However I cannot reach anything else on the inside of my network.
I'm using the default address scheme for the LAN side of the router and the default for the VPN being...
192.168.1.0/24 LAN and 10.8.0.0/24 VPN
As there is very little means to debug what is going on here could anyone have a guess at what is happening here.
On the MAC I have used both TunnelBlick and Viscosity OpenVPN clients.