@aadrianperezz Hopefully I can help. When you introduce a new Deco into an existing mesh set up, you should add the new deco as a satellite / mesh unit, then within the Deco app, you can then swap...

@Kemalg as I reported earlier in this thread, and direct to TP Link, I have the same issue but using Cloudflare DoT, accepts the address and tests fine via the deco app, but doesn't work on clients....

@iresLeandro +100 for this. If you go back a few posts, you'll see the issues I had after installing 1.3.0 rel. 47291, reverting back to 1.3.0 rel. 11551 I'm at least able to use the network...

You might have a faulty wan/lan port 1, which is very common for these XE75 v1 units, check the community here, there a massive thread for faulty port 1's. They fail for no reason, swapping to the...

@Tsopic I feel for you. Firmware version 1.2.10 was absolutely terrible for me. I moved to early release firmware 1.3.0 release 11551 and it's been very good. TP Link also released another firmware...

@David-TP Further to my original posts in the community forum, I wanted to provide some further feedback. After you replied saying firmware version 1.3.0 rel 47291 only includes the NAT feedback...