Fl1nst0neLV2Online
Following: 0Followers: 1
Forums/ 3G/4G Routers/MiFi
2020-05-22 15:51:39
Re:Archer MR600(EU) V1 - BETA Firmware - Allowing selection of 4G+bands for Archer MR600 manually
@kLumpat Just had the issue that you mentioned Been rock solid for a couple of weeks and the last couple of days about lunchtime the bands swap over somehow. Normally bands '1,20' indicated in status...
0HELPFULS
Forums/ 3G/4G Routers/MiFi
2020-05-20 13:44:26
Re:Show seperate signal strength for each 4g/LTE antennas
@Techcareuk I don't think there is anything stopping you removing one antenna and then viewing the signal strength for the remaining antenna. Then repeat for the other antenna? that might work? CheerZ
0HELPFULS
Forums/ 3G/4G Routers/MiFi
2020-05-19 21:35:59
Re:Archer MR600 Hardware Version: V1
@Venni-casnigo Here you go: https://static.tp-link.com/2020/202004/20200420/Archer_MR600v1_1.1.0_0.9.1_[200417-rel75138]_up_boot_2020-04-20_08.44.31.zip CheerZ
0HELPFULS
Forums/ 3G/4G Routers/MiFi
2020-05-18 14:47:52
Re:Broadband woes in lockdown - Archer MR600 4G+ load-balanced solution with ADSL
(Update) Please use the table below when viewing your signal strength under the 'Advanced' tab: RSRP(dBM) RSRQ(dB) SNR(dB) (RF Conditions) Excellent >=-80 >=-10 >=20 (RF Conditions) Good -80 to -90...
1HELPFULS
Forums/ 3G/4G Routers/MiFi
2020-05-18 14:41:47
Re:How to check network strength on TP Link Admin Panel
@amolkalhapure I only have the MR600 router but use to have the MR200 router and both have these values listed under the 'Advanced' tab. I made a presumption that the MR400 router also llisted these...
0HELPFULS
Forums/ 3G/4G Routers/MiFi
2020-05-18 09:46:11
Re:How to check network strength on TP Link Admin Panel
@amolkalhapure I believe in the 'Advanced' tab you should also see RSRP, RSRQ & SNR values, which are all related to your signal strength. Use the following chart to help: RSRP(dBM) RSRQ(dB) SNR(dB)...
2HELPFULS
12345...