AX50 with RE505X, or Deco M9?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have a dead spot in my house, and looking to buy an Archer AX50 with a RE505X extender, or the Deco M9 (three pack)
I know they are different setups, but wanted to ask general recommendations (or if there are better ones) on which to buy. Around 25 devices in the house using wifi, no need for smart IoT devices, but needs to cover two floors.
The AX seems more useful for the iPhone 11 and iPad Pro (they're the only two devices with WiFi 6), but the Deco for a more wider spread. I have a 200mb fibre line.
Thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@B00mer By the design, an extender works several ways. The most common is the extender sends a message on one of the networks say 5GHz and waits for a reply and sends it back on the same network. It connects like any other WIFI device in that is can not send and receive packets at the same time sort of like a CB radio, either you are talking or your are listening. To overcome this. many extenders can transmit on one network such as the 5GHz and receive on the other network in this case the 2.4 GHZ. Better, but you are restricted to the slower speed of the 2.4GHz network. Some extenders now have a backhaul channel. It uses one network and then backhauls on Ethernet, a third channel, or across the electric lines. The system design is to get more coverage. A Mesh system is designed for speed, coverage, and more devices.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Are you sure that RE505 will reduce speed in onemesh mode? mistermajik you want to connect RE505 with AX50 via wifi or ethernet?
- Copy Link
- Report Inappropriate Content
@B00mer it wouldn't have connected via ethernet (too far away) and also the OneMesh didn't connect.
I bought a Deco M9 3-pack and it's been nothing but brilliant since.
- Copy Link
- Report Inappropriate Content
@B00mer By the design, an extender works several ways. The most common is the extender sends a message on one of the networks say 5GHz and waits for a reply and sends it back on the same network. It connects like any other WIFI device in that is can not send and receive packets at the same time sort of like a CB radio, either you are talking or your are listening. To overcome this. many extenders can transmit on one network such as the 5GHz and receive on the other network in this case the 2.4 GHZ. Better, but you are restricted to the slower speed of the 2.4GHz network. Some extenders now have a backhaul channel. It uses one network and then backhauls on Ethernet, a third channel, or across the electric lines. The system design is to get more coverage. A Mesh system is designed for speed, coverage, and more devices.
- Copy Link
- Report Inappropriate Content
thanks. I was thinking about AX50 + RE505X in my house (I have ethernet cables) but I think i will choose Deco
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2754
Replies: 6
Voters 0
No one has voted for it yet.