Unable to ping/communicates between the devices connected to the Omada Network
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Good Afternoon,
I'm new on this community.
I have an Omada Network with the following architecture:
- 1x OC200 controller (Controller version: 4.2.4 and Firmware version: 1.7.1 Build 20201016 Rel.62818)
- 2x EAP225 (model: EAP225(EU) v3.0; version 2.20.1)
Both are connected to a Fritzx Box Router
I have configured 2 WLAN (One as Guest Network and the other one protected by WPA key).
The problem is that the devices connected to the protected network cannot be communicate each other (I'm not able to ping a device connected to the same SSID).
I'm able to ping only the router or some sites over the internet; I'm not able to use a Wi.fi printer because if I try to find it, it doesn't displayed)
The guest tag is only selected for the Guest Network.
Can someone help me?
Thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Dear @MLee,
MLee wrote
I have a Canon MF634CDW which had the same issue. I couldn't print wireless when connected to any of my EAP225s (2 indoor units & 2 outdoor units). The printer is connected to the 2.4 GHz network..
When I turn off "Airtime Fairness" on the 2.4 GHz network, i can ping the printer and see it. If I turn "Airtime Fairness" back on, printer can't be seen.
Indoor EAPs are running 2.7.0 Build 20200113 Rel. 38287. Outdoor EAPs are running 1.7.0 Build 20200113 Rel. 35383.
May I know the version of the Omada Controller you are using? Is it Omada Controller v3.x?
If all of your EAP devices are compatible with Omada SDN Controller v4.x, it's suggested to upgrade both the Omada Controller and EAP devices to the latest SDN firmware for checking.
As I know, @BeppeTPL has resolved the problem by upgrading the EAP225 to 5.0.0 (the latest firmware at that time period).
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 9861
Replies: 22
Voters 0
No one has voted for it yet.