TL-SG1008P and EAP235

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-SG1008P and EAP235

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-SG1008P and EAP235
TL-SG1008P and EAP235
2021-04-19 19:45:50 - last edited 2021-04-22 10:54:48
Model: TL-SG1008P  
Hardware Version: V5
Firmware Version:

hi guys,

 

i have stupid question, if i interconnect TL-SG1008P  and EAP235 WALL , do i get 1Gbps?

 

Thanks

P

  0      
  0      
#1
Options
1 Accepted Solution
Re:TL-SG1008P and EAP235-Solution
2021-04-20 09:37:57 - last edited 2021-04-22 10:54:48

@pcan 

 

Hey

 

Yes both devices support 1gbps and therefore should connect at the full speed

 

Just ensure you have cat5e or higher cables (cat 6 recommended)

Recommended Solution
  1  
  1  
#2
Options
3 Reply
Re:TL-SG1008P and EAP235-Solution
2021-04-20 09:37:57 - last edited 2021-04-22 10:54:48

@pcan 

 

Hey

 

Yes both devices support 1gbps and therefore should connect at the full speed

 

Just ensure you have cat5e or higher cables (cat 6 recommended)

Recommended Solution
  1  
  1  
#2
Options
Re:TL-SG1008P and EAP235
2021-04-20 10:09:33

@Philbert 

 

thanks very much, just to clarify, 1Gbps over PoE? thanks again.

P

  0  
  0  
#3
Options
Re:TL-SG1008P and EAP235
2021-04-20 10:18:33

@pcan 

 

Yes both will work, they are independent things.

 

The poviding of power via POE is not determined by the speed of the connection.   An AP will require say 6watt of power regardless of the speed its connected at (10, 100 or 1000)

  1  
  1  
#4
Options