Enabling MESH for wired EAP's?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi all,
Does it make any sense to enable the site's MESH functionality when all access points (EAP225, EAP245 and EAP225-oudoor) are connected by wire to the LAN?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
No really no, its pretty much inactive unless you have a non cabled AP powered on and in range.
However, I did have a patch failed recently and was only made aware of this by one of the APs appearing as ready for adoption via Mesh. Saved some time getting this back online until I could address the patch issue
- Copy Link
- Report Inappropriate Content
No really no, its pretty much inactive unless you have a non cabled AP powered on and in range.
However, I did have a patch failed recently and was only made aware of this by one of the APs appearing as ready for adoption via Mesh. Saved some time getting this back online until I could address the patch issue
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 683
Replies: 2
Voters 0
No one has voted for it yet.