EAP225-Outdoor(EU) v1.0 stop working after update to 5.0.9
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
After a few minutes of the online state, got a Missing heartbeat, and was Disconnected after that.
Access point still accessible via network (ping)
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
It seems like the mostly reason is the changing of the controller V5's ports.
Suggest you can check whether Port 29810-29814 is opening in your network.
And this article may help you:
https://community.tp-link.com/en/business/forum/topic/559150
- Copy Link
- Report Inappropriate Content
From network:
nmap -p29810-29814 192.168.111.4 Starting Nmap 7.92 at 2022-07-01 09:03 CEST Nmap scan report for 192.168.111.4 Host is up (0.036s latency). PORT STATE SERVICE 29810/tcp closed unknown 29811/tcp open unknown 29812/tcp open unknown 29813/tcp open unknown 29814/tcp open unknown Nmap done: 1 IP address (1 host up) scanned in 0.22 seconds
On Omada controller:
root@wlc:~# nmap -p29810-29814 0 Starting Nmap 7.70 at 2022-07-01 07:06 UTC Nmap scan report for 0 (0.0.0.0) Host is up (0.000040s latency). PORT STATE SERVICE 29810/tcp filtered unknown 29811/tcp open unknown 29812/tcp open unknown 29813/tcp open unknown 29814/tcp open unknown Nmap done: 1 IP address (1 host up) scanned in 1.44 seconds
- Copy Link
- Report Inappropriate Content
Any update from tp-link team?
- Copy Link
- Report Inappropriate Content
heartbeat missed = losing connection to the controller. they're no longer communicating.
something's blocking. do you run firewalls on the controller side?
do you have multiple dhcp servers? are they getting different IPs?
- Copy Link
- Report Inappropriate Content
@Tedd404 no any firewalls in network, also access point keep connected about 1m after boot, then got a heartbeat and disconnected state, also EAP115(EU) v4.0 in same site working without any issues. Look like it's a firmware defect because before the update all worked fine.
- Copy Link
- Report Inappropriate Content
UP!
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Some questions：
What is the firmware version of your current working and non-working EAP?
Which firmware version was this EAP225 before it was upgraded?
What is your current controller version?
It might be more helpful if you could briefly describe the network topology of all your devices.
Also is this EAP225 actually working properly?
Have you tried RESET EAP and then re-adopt to try it?
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 923
Replies: 8
Voters 0
No one has voted for it yet.