Home

Forums

Stories

Knowledge Base

Home Network Community > Access Points > Dhcp assign very poor

< Access Points

Dhcp assign very poor

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Dhcp assign very poor

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

frankz66

2023-07-13 18:59:10

Posts: 20

Helpful: 0

Solutions: 1

Stories: 0

Registered: 2022-10-17

Dhcp assign very poor

2023-07-13 18:59:10

Model: TL-WA1201

Hardware Version: V3

Firmware Version: 1.10.32 Build 221020 Rel.61052n(4555)

Ciao a tutti , utilizzo un tplink tlw1201 come ripetitore wifi di un altro AP

TP-Link Wireless N Access Point WA801N

Downstream of the 1201 network everything works, but the release of the dhcp by the firewall connected on the 801n is very slow. I tried with a client to connect not to the 1201 but directly to the 801n and it works regularly and the ip release is fast. In short , after 1201 however , the ip addresses are assigned but with a strong delay .

2 Reply

Sunshine

2023-07-14 08:26:22

Posts: 7312

Helpful: 1178

Solutions: 784

Stories: 0

Registered: 2018-12-17

Re:Dhcp assign very poor

2023-07-14 08:26:22

@frankz66

Hi,

WA801N is an access point as well, similar as the TL-WA1201, may I know the topology of your network?

And is there a router in front of the WA801N? If so, please try to connect the TL-WA1201 to the router directly and test if there is the same issue.

In addition, please make sure the DHCP server is disabled on the TL-WA1201 access point, the DHCP Server should be still on your main router.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.

frankz66

LV2

2023-07-15 19:35:30

Posts: 20

Helpful: 0

Solutions: 1

Stories: 0

Registered: 2022-10-17

Re:Dhcp assign very poor

2023-07-15 19:35:30

Thank you for replying . one of the segments of my pfsense firewall is a card dedicated directly to the tl 801 which as previously written transmits an essid xxxx . This essid is relaunched by tl 1201 which downstream of the latter is connected to a series of hosts. Chiaraemnte the dhcp is active only and exclusively on the pfsense. The problem arises only after 1201 or rather the assignment of the ip is very slow. I tried to connect a client before 1201 then to 801 and it works on a regular basis for ip assignment. Describing my topology is a bit complicated as I have a cluster with 3 nodes in Ha and one of the main virtual machines is the pfsense .

Dhcp assign very poor

Dhcp assign very poor

Information

Voters 0

Tags