Access LAN over WAN interface
Hello
ER707-M2 WAN port is behind the ADSL modem with network 192.168.2.0. ADSL modem has also clients on 192.168.3.0 network. ER707-M2 LAN network is 192.168.1.0. What the are settings to be made on ER707-M2 for accessing from 192.168.3.0 network to 192.168.1.0? I tried NAT DMZ and Routing policy, no success?
Thks
Gokalp
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
There are two ways to do this, both of which defeat the purpose of having the ER707 in the first place
Disable NAT on its VLAN and setup the ADSL modem with a static route for the ER707 LAN pointing to its WAN IP
One-to-One NAT every single IP on the ER707 lan to an address in the .2 range on its WAN
Why not just make another vlan on the ER707 and have all devices coming off it ?
- Copy Link
- Report Inappropriate Content
There are two ways to do this, both of which defeat the purpose of having the ER707 in the first place
Disable NAT on its VLAN and setup the ADSL modem with a static route for the ER707 LAN pointing to its WAN IP
One-to-One NAT every single IP on the ER707 lan to an address in the .2 range on its WAN
Why not just make another vlan on the ER707 and have all devices coming off it ?
- Copy Link
- Report Inappropriate Content
Thks for the answer. In fact ER707 is behind ADSL modem and I want to access with ER707 VPN to devices on LAN of ER707. Because I used VPN of ADSL modem I asked as above to simplfy. So what is your recomondation here.
Thks
Gokalp
- Copy Link
- Report Inappropriate Content
You can also set up a VPN on the ER707-M2, allowing clients on the WAN side to connect to the LAN side through the VPN.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 74
Replies: 3
Voters 0
No one has voted for it yet.